Page 1 of 1

WAVE setting not saved - DMG (Unlimited) - FL Studio 12.5

Posted: Sat Sep 02, 2017 9:07 am
by freeo
Whenever I load a project in FL Studio a couple of my DMG Unlimited WAVE channels are not saved - they are switched to PULSE. This happens pretty random. Some channels are consistently affected by this. Sometimes they stay on WAVE. Happens across all my project files.

This is extremely annoying... First thing I have to do is go through ALL my WAVE instruments to check if they are still set to WAVE! But sometimes I forget, ruined many render -> deploy to other device -> rehearse cycles.

Tested with:
FL Studio 12.5
FL Studio 12.4
and older FL Studio versions, don't remember when I first spotted this.
Chipsounds 1.877

Re: WAVE setting not saved - DMG (Unlimited) - FL Studio 12.5

Posted: Tue Sep 05, 2017 9:15 am
by davidv
Wondering if FL sends program change=0 or NOTE On 0 upon start. This might explain this.
Would need to investigate.

Re: WAVE setting not saved - DMG (Unlimited) - FL Studio 12.5

Posted: Tue Sep 05, 2017 9:27 am
by davidv
davidv wrote:Wondering if FL sends program change=0 or NOTE On 0 upon start. This might explain this.
Would need to investigate.


To test the former (and probably most logical explanation). If you do not use program changes, you can try by removing the Program Changes to KS logic, by editing {install dir}/programs/pc2ks.sfz and clearing everything out in there?

Re: WAVE setting not saved - DMG (Unlimited) - FL Studio 12.5

Posted: Fri Sep 08, 2017 2:06 pm
by freeo
I've renamed the file pc2ks.sfz and started one of the affected project files, see attached screenshot.

Re: WAVE setting not saved - DMG (Unlimited) - FL Studio 12.5

Posted: Fri Sep 08, 2017 2:46 pm
by davidv
freeo wrote:I've renamed the file pc2ks.sfz and started one of the affected project files, see attached screenshot.


Hi
You need to edit the file and remove what is in it, not remove/rename the file itself.
Cheers

Re: WAVE setting not saved - DMG (Unlimited) - FL Studio 12.5

Posted: Sat Sep 09, 2017 4:41 am
by freeo
Progress!

Opening the old project 1st time: still Pulse. I've set to Wave and resaved, then opened again: It remained at Wave!

These were the lines I've commented out (nothing else was in the file previously):

Code: Select all

// <midi>
// type=com.Plogue.Aria.MIDI.Prog2KS
// vendor_specific=$SW_LOKEY|$SW_HIKEY

Re: WAVE setting not saved - DMG (Unlimited) - FL Studio 12.5

Posted: Sat Sep 09, 2017 6:59 am
by freeo
UPDATE: Not resolved. Just started a new project, worked for quite a while, closed. Reopened. Pulse again... However, it doesn't seem to happen as consistent as before, as my previous project files are ok for now.