I attempt to understand, how to set incoming MIDI notes to waiting before properly (free) MIDI out port will be found:
1)I have a MIDI note on a MIDI input
2)I have a Map operator (red color on the picture) for marks 16 MIDI channels as "free" and "busy"
3) Before sending a MIDI note to a one of 16 MIDI ports, I need to test it's status: if port N is "free" - send a note to port N, else N = N+1 and go to 3)
Is it possible to make such "test cycle" in Bidule without loose incoming notes? as I understand, for this cycle some time may be needed, so - need I to keep incoming MIDI data in buffer?
General Discussion about Plogue Bidule
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 8 guests