To Halve clock input

Post your groups/layouts here

Moderators: davidv, seb@plogue

amGOam
Posts: 12
Joined: Fri Sep 04, 2015 4:10 am

To Halve clock input

Postby amGOam » Sun May 22, 2016 8:57 am

Hi,
i use A&H Xone2D Clock section to send BPM into Bidule.

The Xone2D minimum BPM is 70 ( :twisted:) so to go slower with this setup i need a Plogue Bidule inside solution.

Idea: To halve the input clock tempo.
When i will set 100 BPM on the xone, Bidule will play on 50 BPM. Is it possible to do this??
thanks Andrea

seb@plogue
Site Admin
Posts: 9593
Joined: Tue Mar 02, 2004 7:23 pm
Location: Montreal
Contact:

Re: To Halve clock input

Postby seb@plogue » Tue May 24, 2016 8:44 am

The easiest would probably be to use a Sync Extractor -> divide tempo -> Sync Creator and use the Sync Creator as the sync source.

amGOam
Posts: 12
Joined: Fri Sep 04, 2015 4:10 am

Re: To Halve clock input

Postby amGOam » Thu Jun 09, 2016 7:43 am

I try the config into the attachments but doesn't seems to go.

I can't send start and stop to the step sequencer and the tempo doesn't seems divided.

Any Ideas?
Attachments
13393550_10209901330395727_1875521507_n.jpg
13393550_10209901330395727_1875521507_n.jpg (148.58 KiB) Viewed 2491 times

URM
Posts: 113
Joined: Fri Dec 31, 2004 1:37 pm
Location: Toronto
Contact:

Re: To Halve clock input

Postby URM » Thu Jun 09, 2016 11:00 am

Looks like you need to set the sync source of the sync extractor to be the midi clock to sync bidule.

Also connect the left pin (playing 1/0)) on the sync extractor to the left pin (playing gate) of the sync creator so that when the sync extractor gets a play message from the midi clock to sync it will activate the sync creator and put it into play.

You'll also need a value connected to the right top pin of the divider so that the divider knows what to divide by so for example if you want to turn 100 BPM into 50 BPM then connect a constant (builing blocks/math) with a value of 2 to the right top pin of the divider.

I'd also connect the left pin on the sync extractor to a Parameter Modulator (absolute) and parameter link the modulator to send a trigger to reset the sync creator back to bar one on receiving a play message.

Quick bidule example (you'll need to connect the midi clock to sync bidule to your Xone Midi in bidule) attached so hope this helps.

Jamie
Attachments
midi clock to sync halfed.bidule
(8.86 KiB) Downloaded 63 times


Return to “Bidule Layouts”

Who is online

Users browsing this forum: No registered users and 2 guests